Specifications

ASSEMBLY

Before mounting the saw on tegs or a stand or a bench,

the Table _nsert and Btade Squareness must be

Choked at this time.

INSTALLING HANDWHEELS

1. Stide t,_e _evation bandy,heel onto its shaft. Line up

the flat spot on the shaft with the set screw in the

handv,dseol.Using a hex "L_Iwrench tighten the set

screw securely against the flat spot on the shaft,.

Repeat this same proco-xJureto instaJl the ti_t hand-

wheek

ELEVATION

HANDWHEEL

\ TILT HANDWHEEL

I WARNtNG: To avoid injury from accidental start, 3732_N.

I make sure switch is "OFF" and plug is not con- HEX "'L"WRENCH

t netted to power.

CHECKING TABLE iNSERT

_nsert should be flush with tabie top Chec_ as

shown Loosen flat head screw that holds insert and

adjus! the four set screws as necessary [ighten flat

r'_ead screw Do not tighten screw to the point where

_tdeflects the inse£

CAUTION: insert must be even with the table sur-

face. inserts too high or low can let the work-

piece "snag or catch on uneven edges.

Workplece could twist and kick back.

2 To remove insert,

A. Make sure saw _s OFF an(] unplugged.

B Loosen Screw.

C, Luft =nsert from front end, and _ull toward front of

SaW.

3. To replace insert,

A Make sure saw is off and unplugged.

B. Place insert into insert opening m table and push

toward rear of saw to engage spring clip and until

keyslot =n insert will drop over screw. Tigl_ten

screw.

C, Do not tighten screw to the point where it will

deflect the insert.

PHILLIPS

FLAT HEAD

SCREW