Specifications

4. Thedeflectorismountedtotherearof thesawon
theleftsideviewedfromtherear.Inserttwo1/4-20x
5/8"hexheadscrewsthroughtheoutsideholesof
thedeflector,marked"X".andthroughthebottom
frameofthesawcabinet.InstallIockwasherandnut
to eachscrew.Aligndeflectorwithsawcabinet.
"l]ghtennuts.
5. Connectoneendofthe2-1/2"x 7' hosetothedis-
chargeopeningandtheotherendtoyourCRAFTS-
MANSawDustCollectorSystemorWet/DryVac.
I WARNING: Blade exposure. Remove and install J
door only with saw off, and unplugged,
6. To remove door, push gently down on lower tab with
thumb while Dulling OUtat bottom of door with fin-
gers.
This completes the installation process and the table
saw dust collector is ready to use.
REAR OF
SAW BASE
CABINET
0
LEG SET
LOWER TAB
• Push Tab Down X
• Pull Out On Bottom Edge Of Door
18