Specifications

MOUNTING THE MOTOR

1. From among the loose parts find the following hard-

ware:

4 Carriage Bolts, 5/16-t8 x 3/4'! tong

4 Hex Nuts, 5/16-18 (approx. dia. of hole 5/16")

4 Lockwashers, 5/16 in, External Type (apprex,

dia. of hole 5/! 6")

1 Cast Iron Motor Pulley

2. Place motor on MOTOR BASE, insert bolts through

holes in base...then through the motor. Install lock-

washers and nuts,

3. Position motor so that edge of MOTOR MOUNTING

BASE and MOTOR BASE are even, slide motor all

the way to the RIGHT.

4. Loosen set screw in motor pulley using 5/32 in, Hex

"L" wrench. Slide pulley on shaft with HUB away

from motor. DO NOT TIGHTEN SETSCREW.

5. Install 3/16 in, square key (furnished with motor) in

grooves in pulley and motor shaft. DO NOT TIGHT-

EN SETSCREW,

6. Lift motor and insert the TWO PINS on motor base

into HOLES in cradle, push motor in as far as it will

go,

7. Lower the blade, install belt on saw pulley and motor

pulley.

8, Sight along edges of both pulleys and move motor

pulley so that belt is parallel to the edges of both pul-

leys, tighten the setscrew in the motor pulley.

9, iMPORTANT: Measure the distance from end of

motor shaft to pulley, mark this dimension down; you

wilt need it later when reinstalling the pulley.

CARRIAGE

BO_

5/16" HEX NUT

5/16" EXTERNAL LOCKWASHER MOTOR PULLEY

CRADLE

MOTOR

BASE

SLOT

WASHER

EDGE OF WASHER

EVEN WiTH END

OF SLOT