Specifications

3 P_ace the head of a com_r_at_on square _n the

GROOVE ad_us_ blade of sqL_are so treat _I jus!

toucl_es t_e _D of lb,e MARKED top,n,

4 Move sq{_are to REAR rotate blade to see if - - -

MARKED tooth ag;_n toucr}es [:_ade of square.

5. tf tooth touches square at FRONT arid REAR saw-

btade is PARALLEL to MITER GAUGE GROOVE FRONTTRUNNION REARTRUNNION

6 if tooth does no; touch zr_e same amount, .the

mechanism underneath must be adjusted to make

the biade PARALLEL to GROOVE

A. Rear trunmon must be moved TOWARD the

combination square if there is a space oetween

marked tooth and end of square in step 4

B. Rear trunnion mus! be moved AWAY" from the

square ff marked tooth pushes souare out of pos_-

t_on in the groove,

7. LOOSenall three screws that hold the rear trunnton

and all three screws that hold the front trunn_orL

NOTE; All six screws can be reached through back of

saw. Use a 9/16-in wrench. To reach left-hand front_

trunnion screw, tilt blade to 45 d_grees After loosening

screws reposlbon blade at 90 degrees.

REAR-TRUNNION SCREWS

RIGHT-HAND CENTER FT-HAND

/ (BEHIND_ (B_,_ND HERE)

_RONT-TRUNNIONSCREWS

8, Using a wood block and mallet as shown, move rear

trunmon to right or left as required to realign the

blade, tf necessary, shift front trunnion _n sLmilar

manner: but do NOT move front trunnion unless

necessary Recheck the alignment with the square.

then securely rebghten all six trunnion screws,

EDGE OF TRUNNION

CLAW HAMMER

WOOD BLOCK

LOOKING ON TOP

OFTABLESAW

EDGE OF CRADLE

REAR OF SAW