Specifications

tf b_adeisNOTSQUAREtotabIe.,,the90degreestop
screwmustbeADJUSTED
A. Unscrew 90 degree STOP SCREW three to four
_ums usil_g 3/16 tn HEX L" wrench.
B -rum tilt handwheet ciockwise one turn taen turn
handwnee_ counterc½ockwise u_tit blade _s square
w_tt_table
C Screw 90 degree stop screw IN until it
stops...check once again for squareness and
react!ust screw, if necessary.
/
/
/
/
/
/
45 ° POSITION
TILT blade to LEFT as far as _twilt go.
A. Place an ACCURATE square against blade.
Make sure square is not touching the TIP of one
of the saw TEETH,
If blade is 45 degrees to table;
A. Check pomter,
If POINTER DOES NOT point to the 45 degree mark
on thescale;
A, Remove Elevation Handwheel.
B. Loosen two screws on scale and adjust scale until
POINTER points to 45 degree mark
C. Install Elevation Handwheel.
SCALE
tf blade is NOT 45° TO TABLE_,STOP SCREW and
SCALE must be ADJUSTED.
1. Unscrew 45 degree STOP SCREW three to four
turns using 3/16 in. setscrew wrench.
2. Turn tilt handwheel until blade is 45 degrees to the
table.
3. Screw 45 degree stop screw tN until it stops...check
once again and readjust screw, ifnecessary.
/
/
/
45°
STOPSCREW
60