Owner`s manual

bl h °
frou e s ootung-accessornes
TROUBLESffOOTJHGCHART
TROUBLE
Motor will not run
Excessive vibration
Cannot make square cut
when crosscuMing
Cut binds, burns or
sta||s motor when
rippQng
PROBABLE CAUSE
1. Defective On-Off switch
2. Defective switch cord
3. Defective switch box
receptacle
4. Motor protector open-
circuit, broken
5, Low voltage
6. Defective motor
I. Improper motor tension
2. Blade out of balance
REMEDY
1, Miter gauge not
adjusted properly
2. Blade not properly
aligned
1. Dull blade with
improper tooth set
2, Warped board
3. Blade not properly
aligned
4. Rip fence not
properly aligned
5. Guard splitter out of
alignment
1. Stop collars not
properly adjusted
I. Dirt and need of
lubrication
I. Replace switch,
2, Replace switch cord,
3. Replace switch box receptacle,
4,
5.
6.
1.
2.
1.
2.
1.
Reset protector by pushing on red button, located on side
of motor (indicated by audible click).
Check power line for proper voltage.
Repair or replace the motor,
See "'Adjusting Pivot Arm Screw" under "Periodic
Maintenance Operations".
Use a different blade.
See "Check and Adjust the Miter Gauge" under
"Assembly and Adjustments".
See "Align Saw Blade with Table Grooves" under
"'Assembly and Adjustments",
Check set and sharpness of blade.
2. True up material,
3, See "Align Saw Blade with Table Grooves" under
"Assembly and Adjustments",
4. See "Check and Adjust the Rip Fence" under "Assembly
and Adjustments".
5. Align splitter with saw blade.
Blade not true at O° 1. See "Adjust Stop Collars" under "'Assembly and
or 45 ° Adjustments".
Tilt and elevating screw 1. See "Lubricate Saw" under "Periodic Maintenance
hand-wheels turn hard Operations".
RECOMMENDED ACCESSORIES
Item Cat No.
BENCHSAWKNOW-HOW
BOOKLET.............. 9-2929
FLOORBASE ........... 9-2227
FLOORBASE ............. 9-1071
RUBBERWHEELS............ 9-2244
TABLEEXTENSION........ 9.28925
STOPRODS................ 9-29924
HOLDDOWNCLAMP ....... 9-29928
Item Cat.No. Item Cat.No.
HOLDDOWNSET 9.3230 MOLDINGHEADONLY- 43/_" 9-3200
UNIVERSALJIG ............. 9-3231 MOLDINGHEAD--5s/s" 9-3215
TAPERJIG .......... 9.3233 DADOHEAD- 7" ....... 9-3257
DADOiNSERT ........ 9-29958 DADOHEAD- S" 9-3249
MOLDINGINSERT ........ 9-29959 BLADESTABILIZERS 94952
MOLDINGHEADSET- 7" 9-3217 SANDINGWHEEL........ 9-22723
MOLDINGHEADSET- 4¾" 9-3221 SAWBLADES....... SEECATALOG
MOLDINGHEADONLY- 7" 9.3214
The above recommended accessories are current and were
available at the time this manual was printed.
25