Owner`s manual

INSTALLING BELT GUARD
1. Remove the belt and motor pulley.
2. Screws furnished with guard are "self threading"
screw them into holes iN BELT GUARD SUPPO'R'T
BRACKET. then remove them
3. Position BELT GUARD SUPPORT BRACKET and
BELT GUARD SUPPORT as shown and install the
screws ... make sure motor shaft is in CENTER of
hole in SUPPORT.
/
BELT GUARD
SUPPORT BRACKET
BELT GUARD
f
TWO HOLES CLOSEST
TOGETHER
% SCREW
\
BELT GUARD SUPPORT
\
PIVOT
SCREW
!
CENTERED
Insta three CLIPS /furnished with guard) 90 ° apart
starting with one cliD at the end of the guard as shown
•.. LONG END of clip facing AWAY from you.
BELT GUARD
OPENING
\
LONG END
5. Reinstall motor pulley the same way it was when you
aligned the belt.
6. Place belt on SAW" PULLEY .. insert end of belt
through opening in END of guard.
7. Silo belt over motor pulley•
18