Manual

22. Carefully move fence against blade.
23. Move front bar unti,I "0" mark on rip scale is
approximately inline with indicator.
Move FRONT bar upwards until fence is
approximately 1/32 in. above table ... tighten
screw at left end of bar.
NOTE" Fold a piece of newspaper making 8
thicknesses and place between rip fence and
table to act as a spacer. This will hold the fence
off of the table approx. 1/32 n.
24. Adjust rear bar so that the fence is
approximately 1/32 in. above table. Make sure it
is square with fence guide bar rod ... tighten
screw at end of bar.
25. Replace 3 screws in rear of table extension.., be
sure top surface of extension is PARALLEL to
top surface of rear guide bar,
8 THICKNESSES
OF PAPER
\
\
26. Move fence to RIGHTedgeofsawtable .., make
sure it is approx. 1/32 in. above table at front and
rear and tighten screws in front and rearguide
bars.
8 THICKNESSES
ALIGNING RIP FENCE - -_
The fence should slide easily along the bars and
always remain in alignment (parallel to sawblade
and miter gauge grooves).
The alignment is maintained by a spring underneath
the fence which bears against the front guide bar.
To move the fence, loosen the lock handle and
grasp the fence with one hand _t th_ front.
14