Operator`s manual

WARNING: BE SURE to read and understand all instructions. Failure to
follow all instructions listed below may result in electric shock, fire and/or serious
personal injury.
WORKAREA SAFETY
1. ALWAYS keep your work area clean and well lit. Cluttered and dark areas invite
accidents.
2. DO NOT operate power tools in explosive atmospheres, such as in the
presenceof flammable liquids, gases, or dust. Power tools create sparks which
may ignite the dust or fumes.
3. ALWAYS keep bystanders, children and visitors away while operating a
power tool. Distractions can cause you to lose control.
PERSONAL SAFETY
1. ALWAYS stay alert, watch what you are doing and use common sense when
operating a power tool. DO NOT use tool while tired or under the influence of
drugs, alcohol or medication. A moment of inattention while operating power
tools may result in serious personal injury.
2. ALWAYS dress properly. DO NOT wear loose clothing or jewelry. Pull back
long hair. Keep your hair, clothing and gloves away from moving parts.
Loose clothing, jewelry or long hair can be caught in moving parts.
3. ALWAYS avoid accidental starting. BE SURE switch is in the "Off" position
before plugging in. DO NOT carry tools with your finger on the switch. Carrying
tools with your finger on the switch or plugging in tools that have the switch in the
"On" position invites accidents.
4. ALWAYS remove adjusting keys or wrenches before turning the tool on.
A wrench or a key that is left attached to a rotating part of the tool may result in
personal injury.
5. DO NOT overreach. ALWAYS keep proper footing and balance at all times.
Proper footing and balance enables better control of the tool in unexpected
situations.
6. ALWAYS use safety equipment. Always wear eye protection. Dust mask,
non-skid safety shoes, hard hat, or hearing protection must be used for appropriate
conditions
7. NEVER stand on tool. Serious injury could occur if the tool is tipped or if the blade
is accidentally contacted.
8. ALWAYS avoid accidental starting. BE SURE switch is in the "Off" position
before plugging in.
3