Owner`s manual

• Beforetuming onthe saw, performa dry runof the

cuttingoperationjusttomakesurethatno problems

willoccurwhenthe cutis made.

• Grasp the saw handlefirmly, press the lock-offtab

down, then squeeze the switchtrigger.Allow sev-

eralsecondsfor thebladetoreachmaximumspeed.

• Slowly lower the blade into and through the

workpiece.See Figures29 and 30.

• Release the switchtdggerand allow the saw blade

to stop rotating before raising the blade out of

workpiece.Wait untilthe electdcbrake stopsblade

from turning before removingthe workpiece from

mitertable.

SUPPORT LONG WORKPIECES

See Figure31.

Longworkpieces need extra supports.Supports

shouldbe placed along the workpieceso it does not

sag. The support shouldlet the workpiecelay flat on

the base ofthe saw and worktable duringthe cutting .

operation.Use the optionalworkclamp or a C-clamp

tosecure the workpiece.

_k WARNING: To avoid sadous personal injury,

always keep yourhandsoutsidethe no hands

zone; at least3 in. from blade. Never perform

any cuttingoperationfreehand (withoutholding

workpiece againstthe fence). The bladecould

grab the workpieceifitslipsor twists.

45° X 45° COMPOUNDMITERCUT

Fig. 30

LONGWORKPIECE

WORKPIECESUPPORTS

Fig. 31