Owner`s manual

cu'rI'ING CROWN MOLDING
Yourcompoundmitersew does an excellentjob of
cuttingcrown molding.In general,compoundmiter
sews do a betterjob of cuttingcrown moldingthan
anyothertoolmade.
In orderto fit properly,crown moldingmustbe com-
pound mitered with extreme accuracy.
The two contact surfaceson a piece of crown molding
that fit fiat against the ceilingand the wall of a room
are at anglesthat, when added together, equal
exactly90°. Most crown moldinghas a top rear angle
(the sectionthat fits flat against the ceiling)of 52° and
a bottomrear angle(the sectionthat fits fiat against
the wall) of 38°.
52o CEILING
W
A
L
L FENCE
TOPEDGEAGAINSTFENCE:
• LEFTSIDE,iNSIDECORNER
• RIGHTSIDE,OUTSIOECORNER
MITERTABLE
O O
LAYING MOLDING FLAT ON THE
MITER TABLE
See Figure32.
To use this methodfor accuratelycutting crown
moldingfor a 90° insideor outsidecorner, laythe
molding withitsbroad backsurface fiaton the miter
table and againstthe fence.
When settingthe bevel and miteranglesfor Com-
poundmiters,rememberthat the seffings are interde-
pendent;changingone angle Changesthe otherangle
as well.
Keep in mindthatthe anglesfor crown moldings are
veryprecisea_nddifficultto set. Since it is very easy
for these anglestoshift,all settingsshouldfirstbe
tested on scrap molding.Also most wallsdo not have
anglesofexactly90°, therefore, youwill need to fine
tuneyour settings.
CORNER
OUTSIDE
FENCE CORNER
BoI"roMEDGEAGAINSTFENCE:
• RIGHTSIDE,INSIDECORNER
• LEFTSIDE,OUTSIDECORNER
MITERTABLE
O O
CROWNMOI.D_IGFLATONMITERTABLE
Fig. 32
25