Owner`s manual

& WARNING: To ensuresafety and reliability,all
repairs -- with the exceptionofthe externally
accessiblebrushes-- shouldbe performedbya
qualifiedservicetechnicianat a Sears storeto
avoid riskof personal injury.
BRUSH REPLACEMENT
See Figure 36.
BRUSH
ASSEMBLYBRUSH
CAP
BRUSH
CAP BRUSH
ASSEMBLY Fig. 36
Yoursaw has externallyaccessible brushassemblies
that should be periodically checkedfor wear.
Proceed u follows when replacement Is required:
• Unplugyoursaw.
,_ WARNING: Failt_reto unplugyour saw could
resultin accidentatstartir_lcausingserious
injury.
• Remove brushcap witha screwdriver.Brush
assemblyis springtoadedandwiltpopout wben
you remove brushcap.
• Remove brushassembly,
• Check for wear. Replace bothbrusheswhen
either haslessthan 1/4 in. lengthof carbon
remaining.Do not replace one side without
replacingthe other.
• Reassembleusingnew brushassemblies. Make
sure curvatureof brushmatches curvatureof
motor and that brushmoves frse_yin brushtube.
• Make sure brushcap isorientedcorrectly
(straight)and replace.
• Tighten brushcapsecurely. Do not overtighten.
28