3-inch STRING TRIMMER 13-pulgadas RECORTADORA DE HILO MODEL NO. 138.98981 138.98981 1-888-266-7096 1-888-266-7096 www.craftsman.com www.craftsman.
Garantía sección inglés Introducción sección inglés .7-8 .8-9 ....10 12 •• TWO YEAR LIMITED WARRANTY FOR TWO YEARS from the date of purchase this power tool is warranted against any defects in material or workmanship. With proof of purchase, a defective product will be replaced free of charge. For warranty coverage details to obtain free replacement, visit the web page: www.craftsman.
For safe operation, read and understand all instructions before using this product. Follow all safety instructions. Failure to follow all safety instructions listed below, can result in serious personal injury. Do not allow children or untrained individuals to use this unit. Check the work area before each use. Remove all objects such as rocks, broken glass, nails, wire, or string which can be thrown or become entangled in the machine.
Avoid Accidental Start – Do not carry plugged in appliance with finger on trigger. Be sure the switch trigger is not engaged before plugging in. Do not use tool if switch trigger does not turn it on or off. Any tool that cannot be controlled with the switch trigger is dangerous and must be repaired. Disconnect appliance from power source before storing, servicing, changing accessories such as cutting line. Such preventive safety measures reduce the risk of starting the tool accidentally.
PROPOSITION 65 WARNING! Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints crystalline silica from bricks and cement and other masonry products arsenic and chromium from chemically-treated lumber Your risk from these exposures varies, depending on how often you do this type of work.
ELECTRICAL When working outdoors with a product, use an extension designated with “WA” on the cord’s jacket. Before using any extension cord, inspect it for loose or exposed wires and cut or worn insulation. **Ampere rating (on product data plate) 0-2.0 Cord Length 2.1-3.4 3.5-5.0 5.1-7.0 7.1-12.012.1-16.0 Wire Size (A.W.G.) 25´ 16 16 16 16 14 14 50´ 16 16 16 14 14 12 100´ 16 16 14 12 10 — **Used on 12 gauge - 20 amp circuit. NOTE: AWG = American Wire Gauge Input....................
Remove supplied screw with a phillips screwdriver from the trimmer head. Fit the grass deflector into the slots on trimmer head. Line up the screw hole in the grass deflector with the center hole in the trimmer head. Install supplied screw and tighten by turning clockwise with a phillips screwdriver. 1-888-266-7096 If any parts are damaged or missing do not operate this product until the parts are replaced. Use of this product with damaged or missing parts could result in serious personal injury.
THE CUTTING LINE TELESCOPING SHAFT DO NOT grasp the exposed cutting line when picking up or holding the trimmer. The shaft can be extended or shortened for ease of use. See Figure 9, page ii. A single 0.065-inch round cutting line is pre-installed on the trimmer. When the cutting line needs replacing, install a new pre-wound spool ADVANCING LINES Unplug the string trimmer. Unscrew telescoping shaft coupler and slide to desired position. Tighten telescoping shaft coupler.
LINE REPLACEMENT See Figure 14, page ii. Please call 1-888-266-7096 for service and location of the nearest authorized service center. Unplug the string trimmer. Remove the spool from the line head. NOTE: Remove any old line remaining on the spool. Cut two pieces of line, each being approximately 9 ft. (2.7 m) long. Use only .065 in. (1.65 mm) diameter monofilament line. Insert the first line into the anchor hole in the upper part of the spool.
1. Strings have become stuck together due to heat or storage time. 1. Unplug trimmer. Open spool cover. Remove spool, unwind line and then rewind onto spool housing. 2. Not enough string present in the spool. 2. Unplug trimmer. Open spool cover. Remove spool and replace with new line or new spool assembly as per instructions in this manual. 3. Strings are tangled in the spool 3. Unplug trimmer. Open spool cover. Remove spool. Unwind and remove tangled line.
13in. 138.98981 To order replacement parts, call 1-888-331-4569. lower shaft. •• 1 2 4 8 5 6 7 3 PARTS LIST Key No. 1 2 3 4 5 6 7 8 Part Number 34105874 34116884-5 33301862 31105874 31106874 31104178 34101176A-1 3220313-3 Description Front handle Knob Edging guide 13" Trimmer guard Auto-feed housing assembly Dual line auto-feed spool Spool cover M4 x16 Guard screw 12 Qty.
A B A C B B A D A - Grass deflector (deflector de hierba) B - Slide over head (Slide over head E A B C F A - Switch trigger (gatillo del interruptor) B - Attach outlet end of extension cord here (acople aquí el extremo del enchufe del cable de extensión B G A - Cord retainer (reten para el cable) B - Switch trigger (gatillo del interruptor) C - Rear handle (cómo rotar el mango trasero) D - Front handle (mango delantero) E - Telescoping shaft (brazo telescópico) F - Grass deflector (deflector de
Fig. 12 Fig. 7 A Fig. 10 B A - Line Advancement Button (Line Advancement Button) A B - Line Cut-Off Blade ( Cutting Blade) B Auto-feed spool Cabeza de auto-comida Fig. 8 A - Rear handle(mango trasero) B - Pull up edging coupler to rotate (arránquese el botón del recorte de bordes para rotar) A Fig. 13 A C B Fig. 11 C E D B F A A - Spool retainer (retén del carrete) B - Spool (carrete) C - Tabs (pestañas) E - Slots (ranuras) D - Eyelets (ranuras) F - Line Head ( Line Head) Fig.
