Operator`s manual

Fig. T-2

Pattern Line

Laser Line

D. Aligning Parallelism (Fig. T-l, T-3 )

1. Adjust laser line parallel to pattern line by turning

screw (3) (Fig. T-1 ). NOTE: Do not overturn this

screw or it may damage internal wiring. Maximum

screw turn is 1/8 turn in each direction.

2. Move laser close to pattern line by turning

screw (4).

3. Fine tune alignment of laser is achieved by adjusting

screw (4) no more than 1/8 turn in each direction.

Fig. T-3

Laser Line Laser Line

Pattern Line