Operator`s manual

Slide this table assembly with the rack onto the

column.

Engage the bottom of the rack (5) with the lip of the

column support (6). Tighten the table bracket lock

handle (4) to lock the table assembly to the column,

NOTE: Do not overtighten.

Install the rack ring (7) on the column so the top lip of

the rack sits into the rack ring,

IMPORTANT: The bottom of the collar MUST NOT be

pushed all the way down onto the top of the rack. MAKE

SURE the top of the rack is under the bottom of the

collar and that there is enough clearance to allow the

rack to freely rotate around the column. Tighten the set

screw (8) using the 3 mm hex wrench.

NOTE: To avoid column or collar damage, DO NOT

OVERTIGHTEN the set screw.

Fig. E

7. Install the table crank handle (9) onto the worm gear

shaft (11) on the side of the table support (12).

8. Line up the flat side of the shaft with the set screw (10)

in the crank handle and tighten the screw with the

3 mm hex wrench provided, Do not overtighten.

Fig. F

INSTALLING THE HEAD (FIG. G)

wAR.I.G t

The Drill Press head is heavy and should be lifted with

the help of two PEOPLE to safely assemble the drill

press head on the column.

1. Carefully lift the head (1) and slide it into the top of

column (2). Make sure the head slides down over the

column as far as possible. Align the head with the

base.

2. Using the 4 mm hex wrench provided, tighten the two

head locking setscrews (3) on the right side of the

head.

Fig. G

INSTALLING FEED HANDLES (FIG. H)

1. Screw the three feed handles (1) into the threaded

holes (2) on the hub assembly (3) and tighten,

Fig. H