Operator`s manual

,_ WARNING 1
For your own safety, turn the switch OFF and remove
the plug from the power source outlet before maintaining
or lubricating your drill press.
Frequently blow out, using an air compressor or dust
vacuum, any sawdust or metal chips that
accumulates inside the motor, pulley housing, table
and work surface. Always wear protective safety goggles.
[ WARNINGI
To avoid shock or fire hazard, if the power cord is worn
or cut in any way, have it replaced immediately by a
qualified electrician or service technician.
LUBRICATION
All of the drill press ball bearings are packed with grease
at the factory. They require no further lubrication.
Periodically lubricate the gear and rack, table elevation
mechanism of the spindle the rack (teeth) of the quill.
Lower the spindle down and oil the spindle sleeve
moderately every three months.
CHANGING THE LASER BATTERIES (FIG. DD)
• Unplug your drill press.
[AWAR"INGI
Failure to unplug your tool could result in accidental
starting causing possible serious personal injury.
1. Open the battery cover (1).
2. Remove and replace the two batteries.
NOTE: Dispose the old batteries properly.
3. Replace the battery cover.
NOTE: Replace with batteries that have a rating
of 1.5 volts (Number 4 series and AAA size or
equivalent). When replacing the batteries, the
battery guide should be thoroughly cleaned. Use a soft
paintbrush or similar device, to remove all sawdust and
debris.
Fig. DD
HELPFUL HINT: Remove the two batteries during long
periods of non-use of the drill. This will reduce damage
to the laser guide from the batteries corroding during
storage.
To protect the drill press from moisture, a protective
coating has been applied to the machined surfaces.
Remove this coating with a soft cloth moistened with
kerosene or WD-40.
I WARNING l
To avoid fire or toxic reaction, never use gasoline,
naphtha, acetone, lacquer thinner or similar highly
volatile solvents to clean the drill press.
HELPFUL HINT: Apply a coat of paste wax to the
table, column and machined surfaces of base to
prevent rust. Wipe all parts thoroughly with a clean
dry cloth.
HELPFUL HINT: If you are not using your drill press
for a long length of time, remove the V-belt from the
pulleys and store outside the drill head. This will
increase of the life of the V-belt.
23