Operator`s manual

NON-THROUGHCUT(FIG.ZZ)
Anon-throughcutisusedto cut
groovesandrabbetsintheworkpiece
withoutexposedtheblade.
i_ WARNING 1
o Only this type cut is made
without installing the blade guard
assembly and anti-kickback
pawls assembly.
o To avoid injury from an accidental
start, make sure the switch is in
the OFF position and the plug
is disconnected from the power
source outlet.
o To avoid the risk of personal
injury. Always use push block,
auxiliary fence and featherboard
when making non-through cut.
1. Before starting the table saw, lower
the blade and riving knife assembly
to the down position.
2. Remove the blade guard assembly
and anti-kickback pawls assembly
for non-through cut.
3. Use the featherboard (1) with
C-clamps (3) to fasten the
workpiece securely.
4. Mount the auxiliary fence (4) with
C-clamps.
5. Use the push block (2) to move the
workpiece.
NOTE: Mount the featherboard to
table as shown, so the leading edges
of featherboard will help workpiece
complete cutting.
Fig. ZZ
Non-through Cut
2
3 1
DADO CUTS (FIG. aa, bb)
I WARNING1
o Only Stackable dado blades can
be used on this saw.
o DO NOT use Adjustable or
Wobble type dadoes.
o The maximum dado cut width is
1/2 in.
o The maximum dado blade
diameter is 6 in.
NOTE: An dado insert plate (part
number 308K not included) is required
for this procedure.
.
Remove the table insert, saw blade,
anti-kickback pawls assembly,
blade guard assembly and riving
knife assembly for dado cuts ONLY.
Reinstall and realign blade guard
for all through-sawing operations.
Install a dado not exceeding 6 in. in
diameter and 1/2 in. in width.