Manual

INTERIOR CUTTING (FIG. V) ....

1. Lay outthe designonthe workpiece(I). Drilla I/4"

holeintheworkpiece.

P_Wkvlv/_,Wd _11_[_

2. Release the tensionknob (2), and removethe blade (3).

Refer toBLADE REMOVAL AND INSTALLATION.

3.Place the workpieceon the saw tablewiththe

workpiecehole over the access hole(4) in thetable.

4. Installthe blade (3) throughthe hole inthe workpiece

and access hole(4) and lower the quickrelease

tensionlever(2).

5. Followthe process, items3-g, under FREEHAND

CUTTING OPERATIONS.

6. When finished making the interiorscrollcuts turn the

scrollsaw OFF, remove the bladefrom the blade holder,

and remove theworkpiecefrom thetable.

Fig. V

Foryourownsafety,turnthe switchOFF and removethe

plug from the power sourcebefore maintainingor

lubricatingyoursaw.

GENERAL

An occasionalcoatof paste wax onthe worktable will

allowthewoodbeingcutto glidesmoothlyacrossthe

worksurface.

MOTOR

1.If the powercord isworn, cut, or damaged in anyway,

haveit replacedimmediately.

2. Do not attemptto oil the motor bearings or servicethe

motor internal parts.

UPPER ARM BEARINGS (FIG. W)

Lubricate theupperarm bearings after every 50 hoursof

use.

1. Carefully lay the saw on its side.

2.Loosenthe bushing withan 8mm hex key.

3. Squirt a generous amount of SAE 20 (lightweight)oil(11

around the shaft end and bearing (2).

4. Let the oil penetrate the bearing assembly overnight.

5. Replace and tighten. Turnthe scroll saw over and

repeat on the other side.

Fig. W