Manual

TROUBLESHOOTING GUIDE
To avoidinjuryfrom accidentalstarting,alwaysturnswitchOFF and unplugthescrollsaw beforemoving,
replacingthe bladeor making adjustments.
ContactyourSears ServiceCenter if for any reasonthe motorwillnotrun.
PROBLEM CAUSE REMEDY
Breakingblades 1.Wrong tension. 1.Adjustbladetension.
2.Overworkingblades. 2. Reducefeed rate.
3.Wrong bladeapplication. 3.Use narrowblade.
4. Twistingbladeinwood. 4.Avoidsidepressureon blade.
Motorwillnot run. 1.Defectivecord or plug. 1. Replace defectivepartsbefore usingsaw again.
2. Defectivemotor. 2. CallSears Service Center.Anyattempt to repair
3.Blownovedoadbreaker, thismotormay create a HAZARD unlessrepair
isdone bya qualifiedtechnician.
3.Pushthemotorswitchto theOFF position.Let
the motorcoo!.
Excessive vibration.
NOTE: There will
alwaysbe some
vibrationpresentwhen
the saw isrunning
because of motor
operation.
1.Improper mountingof
saw.
2. Unsuitablemounting
surface.
3. Loosetable or table
resting againstmotor.
4. Loosemotormounting.
1.See mounting instructionsin this manualfor
proper mounting technique.
2.The heavier yourworkbenchisthe less
vibrationwilloccur.A plywoodworkbenchwill
notbe as goodwork surfaceas the same size
solidlumber.Usecommonsense inchoosinga
mountingsurface.
3.Tightenthetable lockknob.
4.Tightenmotormountingscrew.
Bladenot inline with 1.Blade holders not 1. Loosen cap screws holding blade holder to
blade arm motion, aligned, blade arms. Adjust position of blade holders,
Retighten cap screw.
18