Owner's manual

Installation
Completed installations of header bracket, door bracket with plate and door arm (depending on door type) are shown
below,. The header bracket supports the front end of the Tee rail, The door bracket connects door arm to trolley,
IT IS RECOMMENDED THATTHE OPENER BE INSTALLED 7 FEETOR MORE ABOVE THE FLOOR WHERE SPACE
PERMITS. Follow only those instructions which apply to your door type as shown on Page 5.
STEP1
install Door Bracket and Plate
TO PREVENT DAMAGETO LIGHTWEIGHT GARAGE DOORS, ALWAYS REINFORCE THE INSIDEOFDOOR-
BOTH VERTICALLY AND HORiZONTALLY-WITH 2x4 BOARDS OR ANGLE IRON.
Horizontal brace should be a! least 6 feet long Vertical brace should cover height of top panel. Reinforcement
hardware is not supplied (See No 1 Below.) FASTEN SECURELY AS SHOWN BEFORE INSTALLING DOOR
BRACKET AND PLATE
Sectional Door Installation Procedure
With door closed, locate and mark the vertical center
line of garage door. Extend line onto header wall
above door.
SECTIONAL DOOR
Door
Arm
1. Assemble door bracket and plate as shown Cen
ter bracket on vertical guideline (or up to one foot left
or right of center if necessary)
2. Position bracket assembly on face of door within
the following limits: A. Top edge of bracket 2" to 4"
below the top edge of door, B. Directly below any
structural support across top of door.
Placement depends on your particular needs
3. Mark and drill 5/16"TOP and BOTTOM fastening
holes. Secure bracket as shown
Carriage Bolt
5/i6'*-18x2-t/2 ------------
Door Bracket
Plale
Lock
Washer
Reinforcement
Board for
Lightweight Doors
Inside Edge
of Door or
Reinlofcement Board
Nut
5/16'-1S
All One-Piece Door Installation Procedure
With door closed, locate and mark vertical center line
of door. Extend line onto header wall above door,
NOTE: The door bracket has left and right side
fastening holes. Assemble door bracket and plate
If your installation requires top and bottom fas
tening holes. (Refer to illustration).
Center bracket (with or without plate as required) on
top edge of door as shown Mark and drill two 5/16"
fastening holes and secure door bracket, NOTE; If
door has no exposed framing, drill 3/16" pilot
holes and substitute 5/16" x 1-1/2" lag screws
(not supplied) to fasten bracket to top of door.
Lock Washer
5/16"
NOTE: Door bracket may be installed on face of
door if required for your installation. (Refer to
dotted line drawing). HOWEVER, drill 3/16"pilot
holes and substitute 5/16" x 1-1/2" lag screws
(not supplied) to fasten bracket to door.
Header
Wall
Door Bracket
Plate
(Optional)
10