Owner`s manual

INSTALLATION STEP 7
Install the Light
• Install a 75 watt maximum light bulb in the socket.
The light will turn ON and remain lit for
approximately 4-1/2 minutes when power is
connected. Then the light will turn OFR
• Apply slight pressure on the sides of the lens and
slide the tabs into the slots in the end panel (See
illustration).
• To remove, reverse the procedure. Use care to
avoid snapping off lens tabs.
• If the bulb burns out prematurely due to vibration,
replace with a Garage Door Opener bulb.
NOTE: Use only a standard light bulb, The use of a
short neck or speciafity light bulb may overheat the
endpanel or light socket,
To prevent possible OVERHEATINGof the endpanelor
light socket,
• DO NOTuse short neck or specialty light bulbs.
• DO NOTuse halogen bulbs. Use ONLYincandescent.
Lens Guide
Light Lens
"_"Lens Tab
75 Watt Max,
Light Bulb
INSTALLATION STEP 8
Attach the Emergency Release
Rope and Handle
• Thread one end of the rope through the hole in the
top of the red handle so "NOTICE" reads right side
up as shown. Secure with an overhand knot at
least 1" (25 mm) from the end of the rope to
prevent slipping.
• Thread the other end of the rope through the hole
in the release arm of the outer trolley.
• Adjust rope length so the handle is 6 feet (1.8 m)
above the floor. Secure with an overhand knot.
NOTE: If it is necessary to cut the rope, heat seal
the cut end with a match or lighter to prevent
unraveling,
To prevent possible SERIOUSINJURYor DEATHfrom a
falling garage door:
• If possible, use emergency releasehandleto
disengage trolley ONLYwhen garage door is CLOSED.
Weak or brokensprings or unbalanced door could
result in an open door falling rapidly and/or
unexpectedly.
• NEVERuse emergency releasehandle unless garage
doorway is clear of persons and obstructions.
NEVERuse handleto pull door open or closed. If rope
knot becomesuntied, you could fall.
Tro,, °v h°ind
Rope Release Arm
_ Emergency
Overhand Release Handle
Knot _
18