Owner`s manual

Preparing your garage door
Before you begin:
• Disable locks.
• Remove any ropes connected to garage door.
• Complete the following test to make sure your
garage door is balanced and is not sticking or
binding:
1. Lift the door about halfway as shown. Release
the door. If balanced, it should stay in place,
supported entirely by its springs.
2. Raise and lower the door to see if there is any
binding or sticking.
If your door binds, sticks, or is out of balance, call a
trained door systems technician.
Sectional Door
To prevent possible SERIOUSINJURYOR DEATH:
• ALWAYScall atrained door systems technician if
garagedoor binds, sticks, or is out of balance.An
unbalanced garagedoor may not reversewhen
required.
• NEVERtry to loosen, move or adjust garagedoor,
door springs, cables, pulleys, brackets or their
hardware,all of which are under EXTREMEtension.
• DisableALL locks and removeALL ropes connected to
garagedoor BEFOREinstalling and operating garage
door openerto avoid entanglement.
To prevent damageto garage door and opener:
• ALWAYSdisable locks BEFOREinstalling and
operating the opener.
• ONLYoperate garage door opener at 120V, 60 Hzto
avoid malfunction and damage.
One-Piece Door
Tools needed
During assembly, installation and adjustment of the
opener, instructions will call for hand tools as
illustrated below.
Stepladder
Level (optional)
Tape Measure
and 5/32"
and 1/4"
Pencil
Wire Cutters
Screwdriver
Hack Saw
Adjustable End Wrench