Owner`s manual

INSTALLATION STEP 6
Install theDoorControl
Locatedoor control within sight of door, at a minimum height of 5
feet (1.5 m) where small children cannot reach, awayfrom moving
parts of door and door hardware. If installing into drywall, drill
5/32" holesand use the anchors provided.
1. Strip 1/4" (6 mm) of insulation from one endof bell wire and
connect to the two terminal screws on back of door control by
color: white to 2 and white/red to 1.
2. Door Control Button: Fastensecurely with screws 6ABx1-1/2".
3. (For standard installation only) Run bell wire up wall and across
ceiling to motor unit. Useinsulated staples to securewire in
severalplaces. Do not pierce wire with a staple, creating a short
or opencircuit.
4. Connectthe bell wire to the terminal screws on the motor unit
panel:white to 2; white/red to 1.
5. Position the antenna wire as shown.
To prevent possible SERIOUSINJURYor DEATHfrom
electrocution:
• Besure power is NOTconnected BEFOREinstalling door
control.
• Connect ONLYto 24 VOLT low voltage wires.
To prevent possible SERIOUSINJURY or DEATHfrom a closing
garagedoor:
• Install door control within sight of garagedoor, out of reach
of children at a minimum height of 5 feet (1.5 m), and away
from ALL moving parts of door.
• NEVERpermit children to operateor play with door control
push buttons or remote control transmitters.
• Activate door ONLYwhen it can be seen clearly, is properly
adjusted, and there are no obstructions to door travel.
• ALWAYS keep garagedoor in sight until completely closed.
NEVERpermit anyone to cross path of closing garagedoor.
HARDWARESHOWNACTUALSIZE
I ' I_ IBI1111_111/1411S'_rleIw'I ' I1]:_
(drywall installation)
Drywall Anchors Insulated
Staples
Terminal
Screws
(BACKVIEW)
DOORCONTROLBUTTON
2-Conductor
Bell Wire
Opener
Terminal Screws
Back Panel
of Opener
Antenna
17