Owner`s manual

INSTALLATION STEP 7
Install theLight
Install a 75 watt maximum light bulb in the socket. Light size is
A19, standard neck only The light will turn ONand remain lit for
approximately 4-1/2 minutes when power is connected. Then
the light will turn OFF.
Apply slight pressureon the sides of the lens and slide the tabs
into the slots in the end panel (Seeillustration).
To remove, reversethe procedure. Usecare to avoid snapping
off lens tabs.
UseA19, standard neck garagedoor opener bulbs for
replacement.
NOTE:Useonly a standard light bulb. Theuse of a short neck or
speciafity light bulb may overheatthe endpanelor light socket.
To prevent possible OVERHEATINGof the endpanelor light
socket:
DO NOTuse short neckor specialty light bulbs.
DO NOTuse halogenbulbs. UseONLY incandescent.
To prevent damageto the opener:
DO NOTuse bulbs larger than 75W.
ONLYuse A19 size bulbs.
Lens Guide
Light
Lens Slot
Lens Tab
75Watt Max.
Light Bulb
INSTALLATION STEP 8
Attachthe EmergencyRe/easeRopeand Hand/e
Thread one end of the rope through the holein the top of the
redhandle so "NOTICE"reads right side up as shown. Secure
with an overhand knot at least 1" (25 mm) from the end of the
ropeto preventslipping.
Threadthe other endof the ropethrough the hole in the release
arm of the outer trolley.
Adjust rope length so the handleis 6 feet (1.8 m) above the
floor. Secure with an overhand knot.
NOTE:If it is necessaryto cut the rope, heat seal the cut end with
a match or lighter to prevent unraveling.
To prevent possible SERIOUSINJURYor DEATHfrom a falling
garagedoor:
If possible, use emergency releasehandleto disengage
trolley ONLYwhen garage door is CLOSED.Weakor broken
springs or unbalanceddoor could result in an open door
falling rapidly and/or unexpectedly.
NEVERuse emergency releasehandleunless garage
doorway is clear of persons and obstructions.
NEVERuse handleto pull door open or closed. If rope knot
becomes untied, you could fall.
Tro,,e %h° nd
Rope -- Release Arm
N_ _ Emergency
Overhand _ Release Handle
not
18