Owner`s manual

INSTALLATION STEP 9
ElectricalRequirements
To avoid installation difficulties, do not run the opener at this time.
To reducethe risk of electric shock, your garagedoor opener has a
grounding type plug with athird grounding pin. This plug will only
fit into a grounding type outlet. If the plug doesn't fit into the outlet
you have,contact a qualified electrician to install the proper outlet.
RIGHT @ WRONG
If permanent wiring is requiredby yourlocal code, refer to the
following procedure.
To make a permanent connection through the 7/8" hole in the top
of the motor unit:
• Removethe motor unit cover screws and set the cover aside.
• Removethe attached 3-prong cord.
• Connectthe black (line) wire to the screw on the brassterminal;
the white (neutral) wire to the screw on the silver terminal; and
the ground wire to the green ground screw. The opener must
be grounded.
• Reinstallthe cover.
To avoid installation difficulties,do notrun the openerat this
time.
To prevent possible SERIOUSINJURYor DEATHfrom
electrocution or fire:
• Besure power is NOTconnected to the opener, and
disconnect power to circuit BEFOREremoving coverto
establish permanent wiring connection.
• Garagedoor installation and wiring MUST be in compliance
with ALL local electrical and building codes.
• NEVERuse an extension cord, 2-wire adapter,or change
plug in ANY way to makeit fit outlet. Besure the opener is
grounded.
PERMANENTWIRING
CONNECTION
GroundTab
Green
GroundScrew
Ground Wire Wire
White Wire BlackWire
19