Owner`s manual

Preparing your garage door
Beforeyou begin:
• Disablelocks.
• Removeany ropes connected to garage door.
• Completethe followingtest to make sure your garagedoor is
balancedand is not sticking or binding:
1. Lift the door about halfway as shown. Releasethe door. If
balanced, it should stay in place,supported entirely by its
springs.
2. Raiseand lower the door to see if there is any binding or
sticking.
If your door binds, sticks, or is out of balance,call a trained door
systems technician.
To prevent possible SERIOUSINJUREor DEATH:
• ALWAYS call a trained door systems technician if garage
door binds, sticks, or is out of balance.An unbalanced
garage door may NOTreversewhen required.
• NEVERtry to loosen, move or adjust garagedoor, door
springs, cables, pulleys, bracketsor their hardware,ALL of
which are under EXTREMEtension.
• DisableALL locks and remove ALL ropes connectedto
garage door BEFOREinstalling and operating garagedoor
opener to avoid entanglement.
To prevent damageto garagedoor and opener:
• ALWAYS disable locks before installing and operating the
opener.
• ONLYoperate garagedoor openerat 120V, 60 Hzto avoid
malfunction and damage.
SectionalDoor
One-Piece Door
Tools needed
During assembly, installation and adjustment of the opener,
instructions will call for handtools as illustrated below.
Stepladder
Level (optional)
Tape Measure
Drill 3/16", 5/16"
i_ and 5/32"
0
[_1_ Sockets and Wrench
--U 1/2", 5/8", 7/16", 9/16"
and 1/4"
Pencil
Wire Cutters
Screwdriver
Hack Saw
Adjustable End Wrench