Owner`s manual

OPERATION
IMPORTANTSAFETYINSTRUCTIONS
To reducethe riskofSEVEREINJURYor DEATH:
1. READAND FOLLOWALL WARNINGSAND INSTRUCTIONS.
2. ALWAYSkeep remote controls out of reachof children.
NEVERpermit children to operate or play with garagedoor
control push buttons or remote controls.
3. ONLYactivate garagedoor when it can be seen clearly, it is
properly adjusted, andthere are no obstructions to door
travel.
4. ALWAYSkeep garagedoor in sight until completely closed.
NO ONESHOULDCROSSTHEPATHOFTHEMOVING
DOOR.
5. NO ONESHOULDGOUNDERA STOPPED,PARTIALLY
OPENDOOR.
6. If possible, use emergency releasehandleto disengage
trolley ONLYwhen garagedoor is CLOSED.Weakor broken
springs or unbalanceddoor could result in an opendoor
falling rapidly and/or unexpectedly,causing SEVERE
INJURY or DEATH.
7. NEVERuse emergency releasehandle unlessgarage
doorway is clear of persons and obstructions.
8. NEVERuse handleto pull garage door open or closed. If
rope knot becomes untied, you could fall.
9. If one control (force or travel limits) is adjusted,the other
control may also need adjustment.
10. After ANY adjustments are made,the safety reversal system
MUST be tested.
11. Safety reversalsystem MUST betested everymonth. Garage
door MUST reverseon contact with 1-1/2" (3.8 cm) high
object (or a 2x4 laid flat) on the floor. Failureto adjust the
garagedoor opener properly may cause SEVEREINJURYor
DEATH.
12.
ALWAYS KEEPGARAGEDOORPROPERLYBALANCED(see
page 3). An improperly balanceddoor may NOTreverse
when required and could result in SEVEREINJURYor
DEATH.
13. ALL repairs to cables, spring assembliesand other
hardware, ALL of which are under EXTREMEtension, MUST
be made by a trained door systems technician.
14. ALWAYSdisconnect electric power to garagedoor opener
before making ANY repairs or removing covers.
15SAVETHESEINSTRUCTIONS.
Using Your Garage Door Opener
Your Security+° opener and hand-held remote control have been
factory-set to a matching code which changeswith eachuse,
randomly accessing over 100 billion new codes. Your openerwill
operatewith up to eight Security,tl.° remote controls andone
Security.!,° KeylessEntry System. If you purchasea new remote,
or if you wish to deactivateany remote, follow the instructions in
the Programming section.
Activateyour openerwithany of the following:
• The hand-held Remote Control: Hold the large push button
down until the door starts to move.
• Thewall-mounted Door Control: Hold the push button or bar
down until the door starts to move.
• The KeylessEntry (SeeAccessories): If provided with your
garagedoor opener, it must be programmed before use. See
Programming.
Whenthe openeris activated(withthe safetyreversing
sensorcorrectlyinstalled andaligned)
1. If open, the door will close. If closed, it will open.
2. If closing, the door will reverse.
3. If opening, the door will stop.
4. If the door has beenstopped in a partially open position, it will
close.
5. If obstructed while closing, the door will reverse. If the
obstruction interrupts the sensor beam,the opener lights will
blink for five seconds.
6. If obstructed while opening, the door will stop.
7. If fully open, the door will not close whenthe beam is broken.
The sensor has no effect in the opening cycle.
If the sensor is not installed, or is misaligned, the door won't close
from a hand-held remote. However,you can close the door with
the Door Control or KeylessEntry, if you activatethem until down
travel is complete. If you releasethem too soon, the door will
reverse.
Theopenerlightswill turn on under the following conditions:
when the opener is initially plugged in; when power is restored
after interruption; when the opener is activated. Theywill turn off
automatically after 4-1/2 minutes. Bulbsize is A19. Bulb power is
75 watts maximum
3O