Owner`s manual

ToAdd, Reprogram or Change a Key/ess Entry PIN
NOTE:Yournew KeylessEntry must be programmed to operateyour garage door opener.
USINGTHE"LEARN" BUTTON
1. Pressand releasethe "learn" button on
motor unit. The learn indicator light will
glow steadily for 30 seconds.
3. Releasethe button when the motor unit
lights blink. It has learnedthe code. If light
bulbs are not installed, two clicks will be
heard.
\1/
2. Within 30 seconds, entera four digit
personal identification number (PIN) of
your choice on the keypad. Then press
and hold the enter button.
To changean existing, knownPIN
If the existing PIN is known, it may be changed by one person
without using a ladder.
1. Pressthe four buttons for the present PIN, then press and hold
the # button.
The opener light will blink twice. Releasethe # button.
2. Pressthe new 4-digit PIN you havechosen, then press Enter.
The motor unit lights will blink once when the PIN has been
learned.
Test by pressing the new PIN, then press Enter.The door should
move.
Toset a temporaryPIN
You may authorize accessby visitors or service peoplewith a
temporary 4-digit PIN.After a programmed number of hours or
number of accesses,this temporary PIN expires andwill no longer
open the door. It can be used to close the door evenafter it has
expired. To set a temporary PIN:
1. Pressthe four buttons for your personalentry PIN(not the last
temporary PIN), then press and hold the _, button.
The opener light will blink three times. Releasethe button.
2. Pressthe temporary 4-digit PINyou havechosen, then press
Enter.
The opener light will blink four times.
3. To setthe number of hoursthistemporary PIN will work, press
the number of hours (up to 255), then press_,.
OR
3. To setthe number of timesthis temporary PIN will work, press
the number of times (up to 255), then press#.
The opener light will blink once when the temporary PIN has
been learned.
Test by pressing the four buttons for the temporary PIN,then
press Enter.The door should move. If the temporary PINwas set
to a certain number of openings, remember that the test has used
up one opening.Toclear the temporary password, repeatsteps
1-3, setting the number of hours or times to 0 in step 3.
One ButtonC/ose:Openercan beclosed by pressing only the ENTERbutton if the one button closefeature has beenactivated. This
feature has beenactivated at the factory. To activate or deactivatethis feature press and hold buttons 1 and 9 for 10 seconds. The keypad
will blink twice when the one button close is active.The keypadwill blink four times when one button close is deactivated.
36