Owner`s manual

INSTALLATION STEP 8

Install the Lights

• Press the release tabs on both sides of lens. Gently rotate lens

back and downward until the lens hinge is in the fully open

position. Do not remove the lens.

• Install up to a 100 watt maximum light bulb in each socket.

Light bulb size should be A19, standard neck only. The lights

will turn ON and remain lit for approximately 4-1/2 minutes

when power is connected. Then the lights will turn OFF.

• Reverse the procedure to close the lens.

• Use A19, standard neck garage door opener for replacement.

NOTE: Use only standard light bulbs. The use of short neck or

speciality light bulbs may overheat the endpanel or light socket.

INSTALLATION STEP 7

Install the Battery

• Make sure motor unit is unplugged.

• Using a Phillips head screwdriver, remove the battery cover on

the motor unit.

• Partially insert new battery into motor unit with terminals facing

out.

• Connect red (+) and black (-) wires from motor unit to

corresponding terminals on battery.

• Verify the battery wires are seated in the channel.

• Replace battery cover.

To prevent possible OVERHEATING of the endpanel or light

socket:

• DO NOT use short neck or specialty light bulbs.

• DO NOT use halogen bulbs. Use ONLY incandescent.

To prevent damage to the opener:

• DO NOT use bulbs larger than 100W.

• ONLY use A19 size bulbs.

ALWAYS wear protective gloves and eye protection

when changing the battery or working around the battery

compartment.

Battery Cover

Battery

Channel

Lens

Hinge

100 Watt (Max)

Standard Light Bulb

100 Watt (Max)

Standard

Light Bulb

Release Tab