Owner`s manual

ASSEMBLY STEP 1
Assemble the Rail & Install the Trolley
To avoidinstallationdifficulties, donotrun the garagedoor
openeruntil instructedtodo so.
To prevent INJURYfrom pinching, keep hands and fingers away
from the joints while assembling the rail.
Thefront rafthasa cut out "window" at the door end (see
illustration). Theholeabovethis windowis larger onthe topof
the rail than on the bottom. A smaller hole 3-1/2" (8.9 cm) away is
close to therail edge. Rotate the back rail so it has a similar hole
close to theoppositeedge,about 4-3/4" (12 cm) from the far end.
1. Removethe straight door arm and hanging bracket packaged
inside the front rail and set asidefor Installation Step 5 and 12.
NOTE:Toprevent INJURY while unpacking the rail carefully
removethe straight door arm stored within the rail section.
2. Align the rail sections on aflat surface asshown and slidethe
tapered ends into the larger ones.Tabs along the side will lock
into place.
3. Placethe motor unit on packing materialto protect the cover,
and rest the back endof the rail on top. For convenience,put a
support under the front end of the rail.
4. As a temporary trolley stop, insert a screwdriver into the hole
10" (25 cm) awayfrom the front of the rail, as shown.
5. Checkto besure there are4 plasticwear pads inside the inner
trolley. If they became loose during shipping, check all packing
material. Snap them back into position asshown.
6. Slidethe trolley assembly along the rail from the backend to
the screwdriver.
Trolley
)ered
End
Screwdriver
Window
Cut-Out
Idler
Pulley
Hole
FrontRail
(TO DOOR)
Tapered
End
)ered
End
Tapered
End
BackRails
(TO MOTORUNIT)
Outer Trolley
Inner Trolley __
Wear Pads