Owner`s manual

ONE-PIECEDOORS
Pleasereadandcomplywiththewarningsand
reinforcementinstructionsonthepreviouspage.
Theyapplyto one-piecedoorsalso.
• Centerthedoorbracketonthetopofthedoor,in
linewiththeheaderbracketasshown.Markeither
theleftandright,orthetopandbottomholes.
• Drill5/16"pilotholesandfastenthebracketwith
hardwaresupplied.
Ifthedoorhasnoexposedframing,drill3/16"pilot
holesandfastenthebracketwith5/16"x1-1/2"lag
screws(notprovided)tothetopofthedoor.
NOTE: The door bracket may be instafled on the top
edge of the door if required for your installation.
(Refer to the dotted line optional placement drawing.)
Drill 3/16" pilot holes and substitute 5/16"x1-1/2" lag
screws (not provided) to fasten the bracket to the
door.
HARDWARE SHOWN ACTUAL SmZE
Nut 5/16"-18 Lockwasher 5/16"
Carriage Bolt
5/16"-18x2-1/2"
Header Wall
2x4 Support
--Finished Ceiling--
Header
Bracket
Optional
Placement
of Door
Bracket
Door
Bracket
Vertical
Centerline of
Garage Door
Horizontal and vertical
reinforcement is needed for
lightweight garage doors
(fiberglass, aluminum, steel,
door with glass panel, etc.)
(not provided).
÷
Door
For a door with no exposed framing,
or for the optional installation, use
5/16"x1-1/2" lag screws (not provided)
to fasten door bracket.
Lock
Washer
' 5/16"
Top of Door
(Inside Garage
Top Edge
of Door
Optional
Placement
Carriage Bolt
5/16"-18x2-1/2"
25