Manual

Installation Step 4
Install the Safety Reversing Sensor
(Receiving and Sending Eyes)
Figures 1 and 2 show assembly of brackets and "C" wrap
based on the recolmnended installation of the sensors on
each side of the garage door as shown on page 16.
However, Figures 3 and 4 are variations which may fit
your installation requirelnents better. Make sure the
wraps and brackets are aligned so the sensors will face
each other across the garage door.
1. Fasten the "C" wraps to the mounting brackets having
sqtmre holes, using the hardware shown in Figure 3.
2. Connect each assembly to a slotted bracket, using the
hardware shown in Figure 2.
Note the alignment of the brackets for left and right
sides of the door.
3. Finger tighten the loci( nuts.
4. Use bracket mounting holes as a template to locate and
drill (2) 3/16" diameter pilot holes on both sides of the
garage door, 4"-6" above the floor but not exceeding
6". (See warning on page 16.)
5. Attach bracket assemblies with 1/4"x1-1/2" lag screws
as shown in Figure 2.
6. Adjust right and left side bracket assemblies to the
same distance out froln the mounting snrface. Make
sure all door hardware obstrnctions are cleared.
Tighten the nuts securely.
Figure 1
#10 - 32
Lock Nuts
Mounting Bracket
With Square Holes
"C" Wrap
#10-32x3/8"
Screws
Figure 2
Inside
--Garage--
Wall , ,
1/4 x 1-1/2"
Lag Screws
1/4-20 x 1/2" Carriage Bolts
(with square shoulder)
20
Lock Nuts
"C" Wrap
Mounting Bracket
with Square HoIes
Figure 3
Alternate Wall Mount
Inside
Garage
Wail
Mounting Bracket
with SIot
/_ Mounting Bracket
with Square Holes
Figure 4
Alternate Floor Mount
Inside
Garage
-- Wall _
Garage
Floor
Sensor with wire
Indicator Light
Mounting Bracket
with Square Holes
Mounting Bracket
j with Slot
Attach with
concrete anchors
(not provided)
#10 - 32 x 3/8"
Screw
©
#10 x 32
Lock Nut
Hardware Shown Actual Size
_[] I I I I I I I Ill/! IXlll_ll/12 I I I I I l)
Lag Screw Staples
1/4" - 20 x 1/2"
Carriage Bolts
©
1/4" - 20
Lock Nut
17