Manual

I Installation Step 6

Hang the Opener

Two representative installations are shown. Yours may

be different. Hanging brackets should be angled, Figure

1, to provide rigid snpport. On finished ceilings, Figure 2,

attach a stnrdy metal bracket to strnctural supports before

installing the opener. The bracket and fbstening hardware

are not supplied.

1. Measure the distance from each side of the opener to

the structnral support.

2. Cut both pieces of the hanging bracket to required

lengths.

3. Drill 3/16" pilot holes in the structnral supports.

4. Attach one end of each bracket to a support with

5/16" - 18xt-7/8" lag screws.

5. Fasten the opener to the hanging brackets with

5/16" - 18x7/8" screws, lock washers and nuts.

6. Check to lnake sure the rail is centered over the door

(or in line with the header bracket if the bracket is not

centered above the door).

7. Relnove the 2x4. Operate the door lnanually. If the

door hits the rail, raise the header bracket.

Figure 1

Measure

Distance

5/16"-18x7/8"

Hex Screws

5/16" Lock Washers

5/16"- 18 Nuts

Preferred Range of

Bracket Placement

Supports

Lag Screws

5/16"-18xl-7/8"

Hardware Shown Actual Size

Lag Screw

5/16"-18xl-7/8"

Hex Screw

5/16"- 18x7/8" Nut 5/16"-18 Lock Washer 5/16"

Figure 2

-- FINISHED CEILING --

5/16"-18 Nut

Preferred Range of

Bracket Placement