Manual

Installation Step 10
Install the Lights and Lens
• Install a 100 watt lnaxilmnn light bulb in each socket.
The lights will turn ON and relnain lit for
approxilnately 4-1/2 lninutes when power is connected.
Then the lights will mm OFF.
• Insert bottom lens tabs into slots on chassis and tilt
towards chassis to engage top tabs, then drop down
gently into place. (See ilhtstralT"om)
• To relnove, lift lens up and gently tilt slightly outward
and down, then pull out to clear bulbs. Use care to
avoid snapping off'bottom lens tabs.
• If the bulbs burn out prelnaturely, replace with standard
neck Garage Door Opener bulbs. (Fluorescent bulbs are
not recolranended because of possible interference with
receiver/translnitter signals.)
Light Socket
Bottom Lens Slot
Bottom Lens Tab
OOOOO
Ioo OLI
"_ 100 Watt Max.
x_J
Light Bulb
Top Lens Slot
-. Top Lens Tab
Chassis Insert Bottom Lens Tabs First
Installation Step 11
Attach the Emergency Release
Rope and Handle
TroIley
Trolley
Release Arm
Overhand
Knot
A,_verhand
_Knot
--Rope
_l_REe_ergH_CYle
Do not use the red handle to pull the door open or
closed. Therope knot could become untied and you
couldfall.Usethe emergencyreleaseonlyto disengage
thetrolleyand,if possible,onlywhenthedoorisclosed.
Garagedoorsare heavy.If the door is openwhen the
handleispulled,thedoorcouldcloseinadvertentlyif itis
not properly balanced. Serious injury may result to
personsunderthedoor.Makesurethedoorwayis clear
of personsand obstructionsbeforepullinghandlewhen
doorisopen.
• Tl_'ead one end of the rope through the hole in the top
of the red handle so "NOTICE" reads right side up as
shown. Secure with an overhand knot.
The knot should be at least 1" from the end of the
rope to prevent slipping.
• Tlu_ead the other end of the rope through the hole in the
release arm of the outer trolley.
• Adjust rope length so the handle is 6 feet above the
floor. Secure with an overhand knot.
If it is necessary to cut the rope, heat seal the cut end
with a match or lighter to prevent unraveling.
23