Manual

All ONE-PIECE Door Installation Procedure
Please read and comply with the warnings and reinforcement instructions on page 24. They apply
to one-piece doors also.
Header WalI
2x4 Support --Finished Ceiling--
Header
Bracket
Optional
Placement
of Door
Bracket
Door
Bracket
Vertical
of
Garage Door
Horizontal and vertical
reinforcement is needed for
lightweight garage doors
(fiberglass, aluminum, steel,
door with glass paneI, etc)
Nut
5/16"-18 (_
i
Door ._
Bracket
For a door with no
exposed framing or for
the optional instaIlation,
use 5/16"x1-1/2" lag
screws (not supplied)
' 5/16"
Top of Door
(inside Garage)
Top Edge
of Door
__ OptionaI
Placement
i
___ Carriage Bolt
5/16"-18x2-1/2"
• Cemer the bracket on the top of the door, in line with
the header bracket as shown. Mark holes.
• Drill 5/16" pilot holes and I:asten the door bracket with
hardware supplied.
If the door has no exposed training, drill 3/16" pilot holes
and lhsten the bracket with 5/16"x1-1/2" lag screws (not
supplied) m the mp of the door.
The door bracket may be installed on the top edge of
the door if required for your installation. (Refer to the
dotted line optional placement drawing.) Drill 3/16"
pilot holes and substitute 5/16"xl-1/2" lag screws (not
supplied) to fasten the bracket to the door.
Hardware Shown Actual Size
Nut 5/16"-18 Lockwasher 5/16"
Carriage Bolt
5/16"-18 x 2-1/2"
25