Manual

Installation Step 2 I
Install the Header Bracket
You can attach the header bracket either to the
wall above the garage door, or to the ceiling.
Follow the instructions which will work beet for
your particular requirements.
Fasten the Header Bracket to the Wall
• Center the bracket on the vertical guideline with
the bottom edge of the bracket on the horizontal
line as shown (with the arrow pointingtoward the
ceiling).
• Ma_ either set of bracket holes (do not use the
holes designated for ceiling mount). Drill 3/16" pilot
holes and fasten the bracket securely to a structural
supportwith the hardware provided.
2x4
Structural
Suptoott
j,
,J
4,
" I Door
Highest
Point of Travel
(ofGarage Ooor)
CenterLine
Wall
Moun_n_ _es
"2,
t f
Spdng The nail hole is for positioning
Optional Wall
Mounting Holes
Hardware Shown Actual Size
5/16"-9xl -5/8"
Fasten the Header Bracket to the Ceiling
• Extend the vertical guideline onto the ceiling as
shown.
• Center the bracket on the vertical mark, no more
than 6" from the wall. Make sure the arrow is
pointing toward the wall. The bracket can be
mounted flush against the ceiling when clearance
is minimal.
• Mark holes designated for ceiling mount only. Drill
3/16" pilot holes and fasten the bracket securely to
a structural support with the hardware provided.
Ceiling Mounting Holes
/',,
CE MOU_I_ I_Y
/
The hall hole is f_" positioning only.
YOU must use lag screws to mount
the heaclet bracket.
Header
wall
12