Manual

Installation Step 7

Install the Light

• Install a 75 watt maximum light bulb in the socket.

The light will rum ON and remain lit for

approximately 4-1/2 minutes when power is

connected. Then the lightwill rum OFF.

• If the bulb bums out prematurely due to vibration,

replace with a standard neck "Garage Door

Opener = bulb.

75Walt Max._

Light Bulb

Installation Step 8

Attach the Emergency Release

Rope and Handle

Trolley

Overhand

Knol

Ove_nd

_:-_: : _>_;-,_,_::::s:,_::_ ,x_;,> ¸ ,_- _¥ _H ,:+_>:•

Do not use the red handle to pull the door

open or closed. The rope knot could become

untied and you could fall. Use the emergency

release only to disengage the trolley and, If

possible, only when the door is closed.

Garage doors are heavy. If the door is open

when the handle is pulled, the door could

close inadvertently if it is not properly

balanced. Serious injury may result to persons

under the door. Make sure the doorway is clear

of persons and obstructions before pulling

handle when door is open.

Release Arm

Release Handle

• Thread one end of the rope through the hole in the

top of the red handle so "NOTICE" reads right side

up as shown. Secure with an overhand knot.

The knot should be at least 1" from the end of the

rope to prevent slipping.

• Thread the other end of the rope through the hole in

the release arm of the outer trolley.

• Adjust rope length so the handle is 6 feet above the

floor. Secure with an overhand knot.

If it is necessary to cut the rope, heat seal the cut

end with a match or lighter to prevent unraveling.