Manual
Installation Step 10 I
Install the Safety Reversing Sensor
I
Figures 2 and 3 show assembly of brackets and
"C" wrap based on the recommended installation of
the sensors as shown on page 19,
However, Figures 4 and 5 are variations which may
fit your installation requirements better. Make sure
the wraps and brackets are allgned so the
sensors will face each other across the garage
door.
• Fasten the "C" wraps tothe mounting brackets
having square holes, using the hardware shown
in Figure 2.
• Connect each assembly to a slotted bracket, using
the hardware shown in Figure 3.
Note the allgnment of the brackets for left and
right sides of the door.
• Finger tighten the lock nuts.
• Use bracket mounting holesas a template to locate
and drill(2) 3/16" diameter pilotholes on bothsides
of the garage door, 4"-6" above the f]corbut not
exceeding 6". (See warning on page 19.)
• Attach bracket assemblies with 1/4"x1-1/2"
lag screws as shown in Figure 3.
• Adjust right and left side bracket assemblies to the
same distance out from mounting surface. Make
sure all door hardware obstructions are cleared.
Tighten the nuts securely.
Figure 2
MounUngenc_th
. With _ HOleS "C" Wrap
Figure 3
1/4X1-I/2° 114-20X1/2"Ca_lge
Lag Screws (with_are,shoulder)
i:z!.
I14"-20
LOCI(Nuts
"C"Wrap
Bracket
withSquareHoles
Figure 4
J
Alternate Wall Mount
-- Root-
Mounting Bracket
with Squa_ Holes
withwire
thdicatot Light
Figure 5
./
Alternate Floor Mount
i inside
-Wall
Sensor with wire
fndicator L[ght
J Moun_ng Bracket
Square Holes
, Mounting Bracket
! with Slot
Altac_ with
i ' €oncrete anchors
Hardware Shown Actual Size
© @
SCrew Lock Nut Lag Scrlw/ Carriage Boll LOCkNut
#10-32x3/8" #t0x32 1/4xl -1/2" Insulated Staples 1/4"-20xl/2" 114"-20
_n