Manual

Operation of Your Opener
Activate the opener with any of the following:
• The Remote Control: Hold push button down until
the door starts to move.
• The Door Control. Hold push button down until
the door starts to move.
• The Outdoor Key Switch or Keyless Entry.
(See Accessories.)
When the opener is activated with the Safety
Reversing Sensor installed and correctly aligned:
t. If open, the door will close. If closed, it will open.
2. If closing, the door will reverse.
3. If opening, the door will stop (allowing space for
entry and exit of pets and for fresh air).
4. If the door has been stopped in a partially open
position, it will close.
5. If obstructed while closing, the door will reverse.
6. If obstructed while opening, the door will stop.
7. The garage door will reverse in the closing cycle,
and the opener lightwill blinkfor 5 seconds, when
the invisible beam is broken. If fullyopen, the door
will not close when the beam is broken. The sensor
has no effect in the opening cycle.
Ifthe sensor is not installed, or is not aligned
correctly, the door won't close from any remote
control. However, you can close the door with the
Door Control, the Outdoor Key Switch, or Keyless
Entry, if you activate them until down travel is
cornp/ete. If you release them too soon, the door will
reverse.
The Opener Light will turn on under the following
conditions: When the opener is initially plugged in;
when the power is interrupted; when the opener is
activated. It will turn off automatically after 4-1/2
minute. Bulb size is 75 watts maximum.
Emergency Release
Hanale (Pull Oown)
Manual disconnect
position
I
Emergency Rek_ase Hanale
(Pull Down & Back
TowardsOpener)
Lockout position
Operation of the
Door Control Button
Press to open or close the door.
Press again to reverse the door during the closing
cycle or to stop the door while it's opening.
To open the door
manually:
The door should be fully
closed if possible. Pull
down on the red
emergency release
handle and liftthe door
manually. To reconnect
the door to the opener,
press the Door Control
push button.
The lockout feature
prevents the trolley from
reconnecting auto-
matically. Pull the red
emergency release
handle down and back
(toward the opener). The
door can then be raised
and lowered manually as
often as necessary. To
disengage the Lockout
Feature, pull the
emergency release
handle straight down.
The trolley will reconnect
on the next UP or DOWN
operation.
28