Manual

Assembly Step 4
Install the Chain/Cable
and Attach the Sprocket Cover
1. Pull the cable around the idler pulley and toward
the trolley.
2. Connect the cable loop to the retaining slot on
the trolley, as shown:
• From below, push pins of master link bar up
through cable loop and trolley slot.
• Push master link cap over pins and past pin
notches.
• Slide clip-on spring over cap and onto pin
notches until both pins are securely locked in
place.
3. With the trolley against the pliers, dispense the
remainder of the cable/chain along the rail toward
the powerhead and around the sprocket. The
sprocket teeth must engage the chain.
4. Check to make sure the chain is not twisted, then
connect it to the threaded shaft with the
remaining master link.
5. Thread the inner nut and lock washer onto the
the trolley shaft.
6. Insert the trolley threaded shaft through the hole
in the trolley. Be sure the chain is not twisted.
7. Loosely thread the outer nut onto the trolley
shaft.
8. Remove the locking pliers.
9. Align the tabs on the sprocket cover with the slots
in the mounting plate. Squeeze cover and insert
tabs in slots.
Master Unk
Cable
Idler
Cable
Dispensing Carton
LeaveChainand Cable
Inside D_spensing
Carton to PreventKinking.
Keep Chain and Cable
Taut When Dispensing
Master Link Master
Clip-OnSpdng .Unk Cap
Master
.-Unk Cap
lotted
I Hole
i I
q Master
i_Unk Bar
Trolley Pin
Threaded Notch
Shaft _ Master
Unk Bar
Round
Hole
Sprocket _ Opener
Cover Sprocket
Front Back
Tab Slot Tab Slot
Mounting
10