Manual

One Piece Door Installations
One Piece Door° Jamb Hardware°
Horizonta| Track.
Highest Point
ofir_ave_
_ ,,,_. .........
DOO\\_\ /// TRACK
One Piece Door° No ]rack. Jamb
Hardwares,
Highest Point of
of Travel
//
//
DOOR
4
/i/
JAMB
HARDWARE
One Piece Boor,, No Track. Pivot
Hardware,
Highest Point
of Travel
//
/
DOOR
\,
//
Step 1
INSTALL DOOR BRACKET: (Hardware in plastic
bag will be needed in the following steps). Deter-
mine vertical center line of garage door, Position
door bracket center-on-center with this line at lead-
ing edge of top of door (see illustration), Mark outer
holes. Drill 5/16 inch holes through door top,
Fasten bracket with 5/16 inch carriage bolts, lock
washers and nuts,,
INSTALL HEADER BRACKET: Extend vertical
center line of door onto garage header wall above
door. Reinforce header wall if necessary for header
bracket support, A 2x4 or 2x6 will suffice,. Posi-
tion the header bracket according to door type and
its arc of travel (see illustrations at left edge of page)°
A_
One-Piece Door Without Track: Open door
to highest point of travel, Measure distance
from top of door to floor,, Subtract actual
height of door (top to bottom), Remainder
is door rise (see column 1 of adjoining chart),
Refer to chart for' setting height of header
bracket above door, Place bracket at refer-
enced height and center-on-center with ex-
tended vertical center line of door, Mark
bracket holes, Drill 3/16 inch pilot holes,
Fasten bracket with 5/16 by 1-7/8 inch Iag
screws.
B_ One-Piece Door With Track: Position header
bracket center-on-center with extended verti-
cal center line of door and approximately 2
inches above the horizontal tracks, Mark
bracket holes on wall Drill 3/!6 inch pilot
holes.. Fasten bracket with 5/16 by 1-7/8 inch
lag screws,
Step 3
ATTACH RAIL TO HEADER BRACKET: Place
operator on packing material.. Raise Tee rail until
sprocket bracket joins header b_acket. Align holes..
Attach with 3/8 inch by 3 inch clevis pin. Secure
with cotter pin..
5/16" LOCK
WASHER
LEADING
TOP OF DOOR
\
5/t6' CARRIAGE
BOLT
I
h
_ LAG SCREWS
H_'AD_R _
BRACKET
Door' Rise Location of Header
In Inches Bracket Above Door'
in I riches
Up to 4 10
4 to 8 15
8 to 12" 20
*if door rise is greater than 12 inches, or
if low ceiling clearance doesn't allow
positioning header bracket as shown in
column 2 above, use the remote in-
stallation procedures on Page 17.
PIVOT
-14-