Manual

RadioControls
SEARS DiG|TAL RADIO CONTROL PATA PUEOFOR
The coded signal in Sears Digital Radio Controls can be changed easily without the aid of a serviceman,, The only tool needed
is a flat blade screwdriver Choose your own code by changing position of ON-OFF switches numbered 1 through 9 on the code
switch block., Changing the ON-OFF position of only one switch makes an entirely different code The 9 switches can be ar-
ranged into 5t2 code combinations,
OPENING THE RADIO CONTROLS
FIGURE 1
RECEIVER
STEP 1
Remove receiver cover by gripping top
lip of cover with ends of fingers and
pulling outward (Figure 1) Do not
move printed circuit board compo -
nents
STEP 2
Disconnect the two wire, 24 volt, AC
connector from the receiver (Figure 2)
TRANSMITTER
STEP 3
Remove visor clip from back of trans-
mitter by prying it away from the case.,
Remove the screw (Figure 3),
STEP 4
Carefully turn transmitter case over
(with pushbutton up} Remove top of
transmitter case (Figure 4), Be careful,
Do not move circuit board components
FIGURE 3
FIGURE 2
FIGURE 4
FIGURE 5
HOW TO CHANGE THE CODESWITCHES
_@_: _:;,::_i_ ,
STEP 5
Place the receiver cover with its printed
circuit board alongside that of the
transmitter (Figure 5),. Code switch
blocks should be at the bottom (right
side up for reading).,
STEP 6
Use a pencil or smewdriver to change
switch positions (Figure 6). To change
a code, press one or more switches
either ON orOFF, Changing at! switches
to OFF wil! constitute a code
FIGURE 6
IMPORTANT NOTE: The new code setting must be exactly the same in both the receiver and transmitter, also, in any addi-
tional transmitters used to operate the door, Reconnect the AC connector to the receiver and snap the receiver cover back
into piace,_ The lock switch on some receivers (built into side of case) must be unlocked (Down position),. Reassemble trans-
mitter,. Please keep this instruction sheet for future reference,,
-18-