Operating instructions

20qn. Drill Press
Motor Specifications:
Motor type induction
Continuous duty HP 1
Maximum developed HP 2
Amps 12/6
Volts 120/240
Phase Single
Hertz 60
R,P,M, 1725 (no load)
Product Specifications:
Belt Type
Pulley Type
Number of Speeds
Drill Speeds
Spindle Taper
Chuck TaperJacobs Taper
Chuck Type
Chuck capacity
Chuck to Table dimension
Min,
Chuck to Table dimension
Max,
Chuck to Base dimension
Quill Diameter
Quill Travel
Quill Lock
V-Belt
Step
Motor slide
9
150, 275,325, 460, 500,
540, 1150, 1550, 2200
#3 Morse Taper
#3
Keyed
3/32" ° 3/4" (3 ° 19mm)
2o3/16"
23o5/8"
43"
4o3/4"
Yes
Handb Operation 360 degree rotation
Motor Control Industrial push button
ON/OFF switch with
OFF paddb
Tabb Size 18-3/4" wide x 16-3/4"
depth
Table Tilt Yes
Table Movement Rack and pinion
Table Material Cast iron
Depth Stop Yes
Depth Stop Type Quick Set
Depth Scab Yes
Column Diameter 3o5/8" (92mm)
Base Work Area 16" wide x 13" depth
Depth of Throat 10"
Height 68-1/2"
Width 18"
Depth 34"
Weight 321 pounds
Convenience:
Light
Yes
To avoid electrical shock to yourself and damage to the
drill press, use proper circuit protection, Do not expose
to rain, or use in a damp environment,
The drill press is factory wired for 120V, 60 Hz, opera°
tion, Connect to a 120V, 15 amp branch circuit and use
a 15 amp time delay fuse or circuit breaker, The electri-
cal circuit cannot have any wire size less than #14, To
avoid shock or fire, replace power cord immediately if it
is damaged in any way,