Operating instructions

_ge J
DESCRIPTION
FRONT PANEL AND CONTROLS
FIGURE I
I
e
.
4_
e
METER. Provides following scales-
Low Ohms X 1, 0 to 1,000 Ohms (10
Ohms center scale), HI Ohms X
1,000, (10,000 Ohms center scale)t
RPM Hi 0-6000, Lo 0-1200 RPM,
Volts 0-i6 Lo, 0-32 Hi. Dwell 8
cyl. _)-45 a , 4 cy!. 0-90 °, 6 cyl.
0-60 , Amps, Parers 0-3.2 Volts1
AIte rnator-good/defective zones.
ZERO ADJUSTER. Meter painter
adjustment, if pointer is not on zero,
slowly rotate this plastic slotted screw
right or left to set pointer on zero
line. Check before testing.
RED AMPS SOCKET. Insert RED plug
on Amps lead.
WHITE OHMS SOCKET. Insert WHITE
plug on Ohms lead.
BLUE RPM PICK UP SOCKET. Insert
Blue plug on inductive pickup lead.
6. BLACK - OTHER TESTSSOCKET. In-
sert BLACK plug on test lead.
OTHER TESTS SELECTOR SWITCH.
Always place switch In CENTER posi-
tion for all tests, indlcoted by functlon
switch (No.B) above. Use left hand posl-
tlon for charging Amps and right hand
positton for starting Amps. ALWAYS
return switch to center posltlon when
Amp$ test is completed.
. FUNCTION SELECTOR SWITCH. Used
to select meter range for each test.
A description of each test function is
described on page 4.
. RANGE SELECTOR SWITCH. Select
for HIGH or LOW scale range for VOLTS,
RPM, or OHMS depending on the test
being performed.