Owner`s manual

KNOWYOURSAWcont.

ElectricalConnection

Yoursawhasaprecision-builtelectricmotor.Itshouldbeconnectedtoa power supply that is

120 volts, 60 Hz AC only (normal household current), DO NOT operate this tool on direct

current (DC). A substantial voltage drop will cause a loss of power and the motor will overheat.

Ifyour tool does not operate when plugged into an outlet, double-check the power supply.

I ,/_WARNING: DO NOT attempt to modify this tool or create accessories not I

recommended for use with this tool, Any such alteration or modification is a misuse

and could result in a hazardous condition leading to possible serious personal injury.

I ,/_WARNING: To prevent accidental starting that could cause possible serious I

personal injury,ALWAYS assemble all parts to your saw BEFORE connecting it to the

power supply. The saw should NEVER be connected to a power supply when you are

assembling parts, making adjustments, installing or removing blades, or when not in use.

Your compound miter saw has been factory assembled and adjusted. The blade, miter

lock handle, dust guide and dust bag are the only parts that have to be installed.

TO INSTALL MITER

LOCK HANDLE (See Fig. 9)

1, Place the threaded stud on the

end of the miter lock handle into

the threaded hole in the control arm.

2. Turnclockwise to tighten,

TO INSTALL DUST BAG OR VAC

ADAPTER (See Fig. 10))

This miter saw comeswitha dust bag and

a vacadapter to helpyoukeep the work

area clean. The dustbag isideal for smaller

jobs. Usethe vac adapter tohook up your

saw toa wet/dry vac(sold separately).

Attaching the Dust Bag

1. Place theopen end of thedust bag over

the exhaustportin the upperblade guard.

Attaching the Vac Adapter

The vac adapter can be used with most

weVdry vacs.

1. Place the end of the vac adapter marked

INSERT over the exhaust port in the upper

blade guard,

2. Turn the adapter so the open end is facing

down or toward the rear of the saw.

DustBag