Owner`s manual

DEPTH STOP (conL)

Also, when a new blade is installed, it is necessary to check the clearance of the blade

to the miter table support before starting the saw. Make adjustments if necessary,

Depth Stop Adjustments (See Figure 18)

1. Unplug the saw.

I Z_WARNING: To prevent personal injury, ALWAYS disconnect the I

plug from power source BEFORE assembling parts, making adjustments

or changing blades.

2. To adjust the depth stop use

hex key (included) to loosen the

hex nut at the rear of the miter

saw arm.

3. Use the hex key (included)

to adjust the depth stop

adjustment screw,

4. To lower the blade, turn

the screw counterclockwise.

5. To raise the blade,

turn the screw clockwise.

6. Lower the blade into the

throat plate of the miter table.

7. Check blade clearance and

maximum cutting distance

(distance from fence where

blade enters) to front of miter

table slot.

8. Readjust if necessary,

I /_WARNING: DO NOT start your compound miter saw without I

checking for interference between the blade and the miter table support.

The blade could be damaged if it strikes the miter table support during

operation of the saw.

9. Tighten the screw with hex key (included).

10. To prevent the depth stop adjustment screw from turning while tightening the

hex nut, carefully hold it with the hex key while tightening the hex nut with a wrench.