Owner`s manual

TO REPLACE BLADE (See Figs. 19 - 21) cont.

Your compound miter saw has been adjusted at the factory for making very

accurate cuts. However, some of the components may have been jarred out

of alignment during shipping. Also over a period of time, some readjustment

will probably become necessary due to wear. After unpacking your saw, check

the following adjustments BEFORE using your saw. Make any adjustments that

are necessary and periodically checks the parts alignment to be sure that your

saw is cutting accurately.

I _WARNING: Your saw should NEVER be connected to a power I

source when you are assembling parts, making adjustments, installing

or removing blades, or when not in use. Disconnecting your saw will prevent

accidental starting that could cause serious injury.

NOTE: Many of the drawings in this manual show only portions of your

compound miter saw. This was intentional, so we can clearly illustrate the

points being made. NEVER operate your saw without all the guards securely

in place and in good operating condition.