Owner`s manual

To Crosscut With Your Miter Saw cont.

12. BEFORE turning on the saw, perform a dry run of the cutting operation

just to make sure that no problems will occur when the cut is made.

13. Hold the saw handle firmly, when squeezing the trigger switch.

Allow several seconds for the blade to reach maximum speed.

14. Slowly lower the blade into and through the workpiece, (See Figure 22.)

15. Release the trigger switch and allow the saw blade to stop rotating BEFORE

raising the blade out of the workplece.Wait until the electric brake stops the

blade from turning BEFORE removing the workpiece from the miter table.

BEVEL CU'I-FING

(See Figures 23 and 24)

A bevel cut is a cut made across

the grain of the workpiece with the

blade at an angle to the workpiece.

A straight bevel cut is made

with the miter table set in the

0° position and the blade set

at an angle between 0° and 45 o.

To Bevel Cut With Your Miter Saw

1. Unplug the saw.

/_ WARNING: To prevent personal injury, ALWAYS disconnect the

plug from power source BEFORE assembling parts, making adjustments

or changing blades.

2. Pull out the lock pin and lift the saw arm to its full height.

3. Loosen the miter lock handle. Rotate the miter lock

handle approximately one-half turn to the left to loosen,

4. Press down on miter lock plate to disengage.

5. Rotate the control arm until the pointer aligns with zero on the miter scale.

6. Release the miter lock plate.

NOTE: You can quickly locate 0° by releasing the lock plate as you rotate the

control arm, The lock plate will seat itself in one of the positive stop notches,

located in the miter table frame.

7. Tighten the miter lock handle securely.