Owner`s manual

ToMakea Compound MiterCutWithYour MiterSaw

1.Unplugthesaw.

I _WARNING: To prevent personal injury, ALWAYS disconnect the

plug from power source BEFORE assembling parts, making adjustments

or changing blades.

2. Pull out the lock pin and liftthe saw arm to its full height.

3. Loosen the miter lock handle. Rotate the miter lock

handle approximately one-half turn to the left to loosen.

4. Lift miter lock plate to disengage.

5. Rotate the control arm until the pointer

aligns with the desired angle on the miter scale.

6. Release the miter lock plate.

NOTE: You can quickly locate 0°, 15°, 22_/2°, 30° and 45° left or right by

releasing the miter lock plate as you rotate the control arm. The miter lock plate

will seat itself in one of the positive stop notches, located in the miter table frame.

7. Tighten the miter lock handle securely.

I /_kWARNING: To avoid serious personal injury, ALWAYS tighten the J

miter lock handle securely BEFORE making a cut. Failure to do so could

result in movement of the control arm or miter table while making a cut.

The 45 ° triangle on the miter fence provides for the maximum

clearance required for adjusting the miter saw angle when

making a bevel or compound cut.

8. Loosen the bevel lock knob and move the

saw arm to the left to the desired bevel angle.

Bevel angles can be set from 0° to 45 °.

9. Align the indicator point with the desired angle.

10. Once the saw arm has been set at the

desired angle, securely tighten the bevel lock knob.

11. Bevel angles can be set from 0° to 45 °.