Owner`s manual

SUPPORTLONGWORKPIECES

(SeeFigure27)

Long workpieces require extra

supports. The supports should

be placed along the workpiece

so it does not sag. The support

should allow the workpiece to

lay flat on the base of the saw

and work table during the cutting

operation. Use the work clamp or

a C-clamp to secure the workpiece.

I _WARNING: To avoid serious personal injury, ALWAYS keep your hands outside

the "no hands zone"(red lines); at least 3 inches from blade. Also, NEVER perform any

cutting operation "freehand" (i.e. without holding workpiece against the fence); the blade

could grab the workpiece, causing it to slip and twist.